SIP re-INVITE

 Modifying an Existing Session


   A successful INVITE request (see Section 13) establishes both a
   dialog between two user agents and a session using the offer-answer
   model.  Section 12 explains how to modify an existing dialog using a
   target refresh request (for example, changing the remote target URI
   of the dialog).  This section describes how to modify the actual
   session.  This modification can involve changing addresses or ports,
   adding a media stream, deleting a media stream, and so on.  This is
   accomplished by sending a new INVITE request within the same dialog
   that established the session.  An INVITE request sent within an
   existing dialog is known as a re-INVITE.

      Note that a single re-INVITE can modify the dialog and the
      parameters of the session at the same time.

   Either the caller or callee can modify an existing session.

   The behavior of a UA on detection of media failure is a matter of
   local policy.  However, automated generation of re-INVITE or BYE is
   NOT RECOMMENDED to avoid flooding the network with traffic when there
   is congestion.  In any case, if these messages are sent
   automatically, they SHOULD be sent after some randomized interval.

      Note that the paragraph above refers to automatically generated
      BYEs and re-INVITEs.  If the user hangs up upon media failure, the
      UA would send a BYE request as usual.


14.1 UAC Behavior


   The same offer-answer model that applies to session descriptions in
   INVITEs (Section 13.2.1) applies to re-INVITEs.  As a result, a UAC
   that wants to add a media stream, for example, will create a new
   offer that contains this media stream, and send that in an INVITE
   request to its peer.  It is important to note that the full
   description of the session, not just the change, is sent.  This
   supports stateless session processing in various elements, and
   supports failover and recovery capabilities.  Of course, a UAC MAY



Rosenberg, et. al.          Standards Track                    [Page 86]

---

 
RFC 3261            SIP: Session Initiation Protocol           June 2002


   send a re-INVITE with no session description, in which case the first
   reliable non-failure response to the re-INVITE will contain the offer
   (in this specification, that is a 2xx response).

   If the session description format has the capability for version
   numbers, the offerer SHOULD indicate that the version of the session
   description has changed.

   The To, From, Call-ID, CSeq, and Request-URI of a re-INVITE are set
   following the same rules as for regular requests within an existing
   dialog, described in Section 12.

   A UAC MAY choose not to add an Alert-Info header field or a body with
   Content-Disposition "alert" to re-INVITEs because UASs do not
   typically alert the user upon reception of a re-INVITE.

   Unlike an INVITE, which can fork, a re-INVITE will never fork, and
   therefore, only ever generate a single final response.  The reason a
   re-INVITE will never fork is that the Request-URI identifies the
   target as the UA instance it established the dialog with, rather than
   identifying an address-of-record for the user.

   Note that a UAC MUST NOT initiate a new INVITE transaction within a
   dialog while another INVITE transaction is in progress in either
   direction.

      1. If there is an ongoing INVITE client transaction, the TU MUST
         wait until the transaction reaches the completed or terminated
         state before initiating the new INVITE.

      2. If there is an ongoing INVITE server transaction, the TU MUST
         wait until the transaction reaches the confirmed or terminated
         state before initiating the new INVITE.

   However, a UA MAY initiate a regular transaction while an INVITE
   transaction is in progress.  A UA MAY also initiate an INVITE
   transaction while a regular transaction is in progress.

   If a UA receives a non-2xx final response to a re-INVITE, the session
   parameters MUST remain unchanged, as if no re-INVITE had been issued.
   Note that, as stated in Section 12.2.1.2, if the non-2xx final
   response is a 481 (Call/Transaction Does Not Exist), or a 408
   (Request Timeout), or no response at all is received for the re-
   INVITE (that is, a timeout is returned by the INVITE client
   transaction), the UAC will terminate the dialog.






Rosenberg, et. al.          Standards Track                    [Page 87]

---

 
RFC 3261            SIP: Session Initiation Protocol           June 2002


   If a UAC receives a 491 response to a re-INVITE, it SHOULD start a
   timer with a value T chosen as follows:

      1. If the UAC is the owner of the Call-ID of the dialog ID
         (meaning it generated the value), T has a randomly chosen value
         between 2.1 and 4 seconds in units of 10 ms.

      2. If the UAC is not the owner of the Call-ID of the dialog ID, T
         has a randomly chosen value of between 0 and 2 seconds in units
         of 10 ms.

   When the timer fires, the UAC SHOULD attempt the re-INVITE once more,
   if it still desires for that session modification to take place.  For
   example, if the call was already hung up with a BYE, the re-INVITE
   would not take place.

   The rules for transmitting a re-INVITE and for generating an ACK for
   a 2xx response to re-INVITE are the same as for the initial INVITE
   (Section 13.2.1).


14.2 UAS Behavior


   Section 13.3.1 describes the procedure for distinguishing incoming
   re-INVITEs from incoming initial INVITEs and handling a re-INVITE for
   an existing dialog.

   A UAS that receives a second INVITE before it sends the final
   response to a first INVITE with a lower CSeq sequence number on the
   same dialog MUST return a 500 (Server Internal Error) response to the
   second INVITE and MUST include a Retry-After header field with a
   randomly chosen value of between 0 and 10 seconds.

   A UAS that receives an INVITE on a dialog while an INVITE it had sent
   on that dialog is in progress MUST return a 491 (Request Pending)
   response to the received INVITE.

   If a UA receives a re-INVITE for an existing dialog, it MUST check
   any version identifiers in the session description or, if there are
   no version identifiers, the content of the session description to see
   if it has changed.  If the session description has changed, the UAS
   MUST adjust the session parameters accordingly, possibly after asking
   the user for confirmation.

      Versioning of the session description can be used to accommodate
      the capabilities of new arrivals to a conference, add or delete
      media, or change from a unicast to a multicast conference.





Rosenberg, et. al.          Standards Track                    [Page 88]

---

 
RFC 3261            SIP: Session Initiation Protocol           June 2002


   If the new session description is not acceptable, the UAS can reject
   it by returning a 488 (Not Acceptable Here) response for the re-
   INVITE.  This response SHOULD include a Warning header field.

   If a UAS generates a 2xx response and never receives an ACK, it
   SHOULD generate a BYE to terminate the dialog.

   A UAS MAY choose not to generate 180 (Ringing) responses for a re-
   INVITE because UACs do not typically render this information to the
   user.  For the same reason, UASs MAY choose not to use an Alert-Info
   header field or a body with Content-Disposition "alert" in responses
   to a re-INVITE.

   A UAS providing an offer in a 2xx (because the INVITE did not contain
   an offer) SHOULD construct the offer as if the UAS were making a
   brand new call, subject to the constraints of sending an offer that
   updates an existing session, as described in [13] in the case of SDP.
   Specifically, this means that it SHOULD include as many media formats
   and media types that the UA is willing to support.  The UAS MUST
   ensure that the session description overlaps with its previous
   session description in media formats, transports, or other parameters
   that require support from the peer.  This is to avoid the need for
   the peer to reject the session description.  If, however, it is
   unacceptable to the UAC, the UAC SHOULD generate an answer with a
   valid session description, and then send a BYE to terminate the
   session.

https://tools.ietf.org/html/rfc3261#page-37